Kawasaki KX / KXF Nickel Wurks Bolt Kit 65 80 85 100 125 250 450 500 250F 450F

All New KAWASAKI KX KXF Nickel Wurks Dress-Up Bolt kit! This HIGH QUALITY Nickel Wurks bolt kit is for all... 1984 & Up KX 60 65 80 85 100 125 250 450 500 This kit uses 10.9 grade nickel plated fasteners. They are all designed with performance in mind. Configured to bring your KAWASAKI KX KXF to WURKS status using only the best fasteners. Includes... Full set of modern Fork Guard bolts, 6 Nickel wide head radiator shroud bolts, Nickel seat bolts, 2 correct square nuts for rear fender, a full Nickel Sprocket bolt kit... plastics fender body bolts and fender washers, most visible engine side cover bolts, radiator bolts, shifter bolt, Flange Nuts for cylinder and head, exhaust bolts, most triple clamp and handlebar clamp bolts, front axle pinch bolts, front brake caliper bolts, fuel tank bolts, clutch and front brake perch bolts, and number plate and side panel bolts...all with a hard and beautiful nickel finish. We give you our full assortment of Kawasaki 10.9 grade Nickel Wurks bolts. These bolts fit your bike's engine covers, triple clamps, bar clamps, front brake caliper, front axle pinch bolts, body plastics, radiator bolts, chain slider, swingarm components. Additional bolts may be needed here and there for a restoration depending on your make and model. These are all available as refills in our specbolt website store for around a buck a bolt. M6 Nickel Wurks flange bolts in this kit range in size from M6x10 up to M6x45 and look beautiful used on your engine covers and plastics. M8 Nickel Wurks flange bolts in this kit range in size from M8x12 up to M8x45 and are perfect to replace your old bolts on your seat, front end, triple-clamps, bar mounts, axle pinch bolts, brake caliper mounts etc... M6 Nickel Wurks wide head flange bolts in this kit in 2 sizes. M6x12 & M6x16 are great for mounting radiator shrouds and bodywork plastics. Our Specbolt drilled washers are perfect size and for mounting plastics and bodywork. This kit contains a full assortment of Nickel Plated Flange nuts in M6, M8, and M10 sizes. An assortment of the most needed Fender and Flat Washers are included. A Full set of Nickel Wurks Kawasaki Sprocket Bolts with thread lock pre-applied. Complete with matching flat washers and class 10 flange bolts. A full set of 6 Kawasaki specific Fork Guard Bolts are included in the set. A big improvement over stock. They have been re-engineered to hold the fork guards a little tighter in place and eliminate any wiggle found on some models. This is especially helpful when running a holeshot device. Axle adjuster note: Most all KXs use the M8 Chain adjuster bolt. Only 99-03 KX125 and KX250 take a bigger M10 Chain adjuster and they are not included in this kit. If you let us know right after ordering we can make the change for no additional charge.